So i'm using the c# example as a starting point. I changed the .properties file so it matches my settings like this:
operation#0=Convert
; Source info
source.type=Managed ; Valid values: Physical, Managed, Hosted, HyperV
; Managed source
source.managed.address=192.168.1.230; Source ESX or vCenter server name or IP, e.g 10.0.0.2
source.managed.thumbprint=D4:B9:8F:7F:A5:53:88:5E:6E:A4:B5:97:06:5A:03:F1:A1:91:5A:E4
source.managed.username=user
source.managed.password=pass
source.managed.vm=vm-583; Use the VM MoId as can be seen in MOB, e.g. 'vm-5'
; Target info
target.type=Hosted ; Valid values: Managed, Hosted. Needed for Conversion operation only
; Hosted target
target.hosted.directory=\\192.168.1.100\VirtualMachines\Test\; Target directory, usually network path, e.g. \\10.0.0.5\Shared
target.hosted.networkusername=user
target.hosted.networkpassword=pass
; Target VM configuration
vmtocreate.name=VmName
vmtocreate.vcpu=1
vmtocreate.corespersocket=1
vmtocreate.memory=2048
the rest of the settings is the same as the example.
So I can connect to the converter server. but when i try to submit the job : ConverterServerConversionConversionJobInfo jobInfo = _converterServer.SubmitJob(jobSpec); I get the following error:
Connected to the converter server
Executing operation 'Convert' from properties file '.\V2P.properties'
Failed to execute operation 'Convert' from file '.\V2P.properties'
System.Web.Services.Protocols.SoapException: A specified parameter was not correct:
at System.Web.Services.Protocols.SoapHttpClientProtocol.ReadResponse(SoapClientMessage message, WebResponse response, Stream responseStream, Boolean asyncCall)
at System.Web.Services.Protocols.SoapHttpClientProtocol.Invoke(String methodName, Object[] parameters)
at ConverterApi.ConverterService.ConverterServerConversionManagerCreateJob(ManagedObjectReference _this, ConverterServerConversionConversionJobSpec spec, Obj
ect extraInfo)
at ConverterSamples.ConverterConnection.SubmitJob(ConverterServerConversionConversionJobSpec jobSpec) in C:\VIT\Converter\cs\SubmitWinP2VJob\ConverterConnection.cs:line 291
at ConverterSamples.ConverterOperation.Convert() in C:\VIT\Converter\cs\SubmitWinP2VJob\ConverterOperation.cs:line 646
at ConverterSamples.ConverterOperation.Execute() in C:\VIT\Converter\cs\SubmitWinP2VJob\ConverterOperation.cs:line 191
I just can't figure out how to fix this